Labels again

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein

Post Reply
Dave Burtchell
Junior Member
Posts: 98
Joined: Thu, Jun 30 2005, 10:04PM

Labels again

Post by Dave Burtchell »

Howdy,

Cutting 12 sheets with about 15 parts per sheet. All .dxf files. Starting with sheet 7, the labels started to get goofy. Only about 50% matched. Using 4.77

Anybody?

Dave
Top
Ryan Hochgesang

Post by Ryan Hochgesang »

Hi Dave,

Control Nesting V4.79 has been released, run the update and if you are still seeing the label issue, attach your dxf files and the qty that you nested, and we'll check into the situation.
Top
Post Reply

Return to “Thermwood 3-Axis Machinery”