Error message

[Jeff Christenson]

Hello, I am getting an error message while trying to open an existing job. The message reads " There was an error after opening the JOB file". I have windows XP with 4gb ram. Have been running Ecabs very successfully for years. I cannot open any jobs at all in the custom layout room. I cant even open the job I created just an hour ago. I have tried to restart the compute. Until this is fixed, ecabs is useless. Thank you.

[Gary Puckett]

can you post the job file?

Gary

[Rick Palechuk]

Jeff, check to make sure your path to where the jobs are saved is correct. If that doesn't help, try to post a job as Gary was saying to see if someone else can open it.

[Jeff Christenson]

I tried to send the job file but appears it was to big to load. How would I check to see if it was the correct path?. What I think you mean by sending the job file is this, I was in the reply window on this site and clicked the browse button. I went to the Thermwood folder and opened it up. Then opened the ecabinets folder, then clicked the Rimkus job and clicked add file. It took a long time to load, I then got a message about a big file size. I had to go back to the forum to get this message out. A few minutes ago I tried to open the job and it did load. But while trying to print an image the program stopped responding. Now it wont load again.

Thank you!