Hey How's it going?
Got a prob with holes, when there are holes on both sides of the board but are off centre from each other, The thermwood drills right though to the other side so the hole on the flip side gets drilled in the wrong place cos its over laps the other hole.
I need this fixed!
Cheers
Thom Davies
Hole Problem
Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein
-
Thom Davies
- Guru Member
- Posts: 530
- Joined: Tue, May 17 2005, 6:44PM
- Company Name: Dawn Group
- Country: NEW ZEALAND
- Location: Christchurch New Zealand
-
Daniel Vonderheide
- Thermwood Team
- Posts: 361
- Joined: Wed, May 17 2006, 11:25AM
- Location: Thermwood
Re: Hole Problem
Please send the cabinet in question, the nc file created at the control, and the export from the control to program@thermwood.com so we can try to reproduce this issue.
