What is this appearing in my Code from Rolling Nest ????
\"G01Z-3.1750Fˆòðç\"
Funny code
Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein
-
Nick M Singer
- Guru Member
- Posts: 828
- Joined: Fri, Jun 17 2005, 12:23AM
- Location: South Africa
-
Josh Meyer
Nick,
I would suggest that you verify your feedrate settings for the tool being used as well as the \"min feed rate\" and \"max feed size\" settings in Control Nesting. If these appear correct, I will need you to send your machine.ini and tools.thm files along with the twd or dxf file you are using. Make sure you have updated to Version 4.79! My email is josh.meyer@thermwood.com
I would suggest that you verify your feedrate settings for the tool being used as well as the \"min feed rate\" and \"max feed size\" settings in Control Nesting. If these appear correct, I will need you to send your machine.ini and tools.thm files along with the twd or dxf file you are using. Make sure you have updated to Version 4.79! My email is josh.meyer@thermwood.com
