Profile modeler

Jeremy Schiffer · Post by **Jeremy Schiffer** » Wed, Oct 28 2009, 4:12PM

I've deleted the tools from the MDF door tool group in profile modeler, now profile modeler will not open, it gives an error message saying the tool group wasn't found, and it is reverting to the Generic tool group, but then it fails to open. It also gives this message when opening control nesting. I can't figure out a way to re-add tools to the tool group if profile modeler will not open. Any ideas?

Josh Rayburn · Post by **Josh Rayburn** » Thu, Oct 29 2009, 7:44AM

Oh boy. Yeah, that's an oops - I made a tool group with no tool in it not too long ago, and that had the same effect.
I was only able to patch up by installing a file from Thermwood to fix things up, if I remember right it was a toolset.bin file.

Daniel Vonderheide · Post by **Daniel Vonderheide** » Thu, Oct 29 2009, 9:24AM

Jeremy,

I was just wondering if the files I sent corrected the issue. If not, give me a call, 1-800-221-3865 ext 245 and we'll get this fixed.

Jeremy Schiffer · Post by **Jeremy Schiffer** » Thu, Oct 29 2009, 1:29PM

Yes, thanks. That fixed it. Now I'm encumbered with another problem which I'll post seperately.

Thermwood / eCabinet Systems

Profile modeler

Profile modeler

Re: Profile modeler

Re: Profile modeler

Re: Profile modeler