Presentation View Problems

[John J. Desmond]

I have a long wall, shorter than I have done in the past, and when I go into presentation view it only shows the very center of the wall. If I want a cabinet I have to move it over and minimize it alot. What am I messing up? Did I accidently change something? I attached the render view and the presentation view.

Render View.jpg (47.06 KiB) Viewed 7670 times

Presentation View.jpg (75.31 KiB) Viewed 7670 times

[Gary Puckett]

John,

Have you tried closing the program and reopen it? If it still does it check your view size in the presentation settings and reduce it

Gary

[John J. Desmond]

Gary,

Been there, done that, bought the t-shirt. I did restart the computer, same. I changed the view size, same.

I'm open for more advice.

Thanks

[Gary Puckett]

what happens if you zoom the room in ( make it smaller) then hit presentation view?

Gary

[John J. Desmond]

I have done that also. It just makes the room smaller in the presentation view. That is how I get one cabinet only. I think maybe I am doing something wrong still.

[Bryan J Tanner]

Can you post the job file?

[John J. Desmond]

Sure, here it is.

Charlene.esj

(3.79 MiB) Downloaded 707 times

[Bryan J Tanner]

Hi

Sorry about the delay in replying

I don't know if I'm missing something but I just zoomed out to get the full wall in the render.

I agree that it is probably a fault of some kind, and I don't know what it is.

[Gary Puckett]

John,

Resize the two outer walls to 120"
then do a presentation view. I don't know why but it works

Gary