Hello! Anyone know if it is possible to change the edge banding on only one side of the door/drawer front? I would like to make the top edge banding different from the sides and bottom edges. Thanks in advance for your superior Ecab wisdom!
Matt
Door/Drawer Edge Banding.
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
Matt Schultz
- New Member
- Posts: 6
- Joined: Wed, Jan 06 2010, 12:23PM
- Company Name: Thomson Cabinets Ltd.
-
JohnLashuay
- Guru Member
- Posts: 645
- Joined: Mon, Nov 20 2006, 3:39PM
- Company Name: Rylex Custom Cabinetry-Close
- Country: UNITED STATES
- Location: Pine Island, New York
- Contact:
Re: Door/Drawer Edge Banding.
Matt,
From the cabinet editor, take the part you would like to modify into the Edgebanding Editor. In there, you can make changes.
From the cabinet editor, take the part you would like to modify into the Edgebanding Editor. In there, you can make changes.
-
Matt Schultz
- New Member
- Posts: 6
- Joined: Wed, Jan 06 2010, 12:23PM
- Company Name: Thomson Cabinets Ltd.
Re: Door/Drawer Edge Banding.
Thanks John,
I apprectate the info, unfortunatly it didn't seem to work. It will of course let me edit any of the parts on the case itself, but not any of the door fronts. I can select it, take it into edgebanding, but it will not let me pick any different selections. I hate to be a pain, but am I missing anything?
Thanks!
I apprectate the info, unfortunatly it didn't seem to work. It will of course let me edit any of the parts on the case itself, but not any of the door fronts. I can select it, take it into edgebanding, but it will not let me pick any different selections. I hate to be a pain, but am I missing anything?
Thanks!
-
JohnLashuay
- Guru Member
- Posts: 645
- Joined: Mon, Nov 20 2006, 3:39PM
- Company Name: Rylex Custom Cabinetry-Close
- Country: UNITED STATES
- Location: Pine Island, New York
- Contact:
Re: Door/Drawer Edge Banding.
Matt,
You are right, the doors and drawer faces will not work in the edgebanding editor...sorry!!
I have created a door/ drawer face using just the back of a cabinet. It can then be resized and this kind of part can be taken to the edgebanding editor and changes then can be made.
-John
You are right, the doors and drawer faces will not work in the edgebanding editor...sorry!!
I have created a door/ drawer face using just the back of a cabinet. It can then be resized and this kind of part can be taken to the edgebanding editor and changes then can be made.
-John