Is it just me or does the spline and arc mode not work in shape manager?
Forrest
shape manager
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
Forrest Chapman
- eCabinets Beta Tester
- Posts: 1254
- Joined: Mon, May 30 2005, 2:26PM
- Location: Anderson SC.
- Contact:
-
Kerry Fullington
- Wizard Member
- Posts: 4735
- Joined: Mon, May 09 2005, 7:33PM
- Company Name: Double E Cabinets
- Country: UNITED STATES
- Location: Amarillo, TX
Re: shape manager
Forrest,
I am able to draw a spline and three point arc and make a tool.
Kerry
I am able to draw a spline and three point arc and make a tool.
Kerry
-
Forrest Chapman
- eCabinets Beta Tester
- Posts: 1254
- Joined: Mon, May 30 2005, 2:26PM
- Location: Anderson SC.
- Contact:
Re: shape manager
Thanks Kerry,
I'm updating my video driver to see if that helps.
Forrest
I'm updating my video driver to see if that helps.
Forrest
-
Kerry Fullington
- Wizard Member
- Posts: 4735
- Joined: Mon, May 09 2005, 7:33PM
- Company Name: Double E Cabinets
- Country: UNITED STATES
- Location: Amarillo, TX
Re: shape manager
Forrest,
That can't hurt. If you were using the software for quite a while this may have been one of those times that you just needed a re-start of Windows and eCabinets.
Kerry
That can't hurt. If you were using the software for quite a while this may have been one of those times that you just needed a re-start of Windows and eCabinets.
Kerry