Island

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Post Reply
Pete Rafferty
New Member
Posts: 17
Joined: Sun, Jul 01 2007, 4:06PM
Location: San Antonio, TX
Contact:
Contact Pete Rafferty

Island

Post by Pete Rafferty »

A large island with angled corners, flutes and corbels.
What is the easiest method? Would it be back to back walls and 4 angled set at the correct position. If the walls are not to be seen are they set to 0?

Corbels, flutes, onlays etc ... can some one point me in the right direction?

Thanks
Pete
Top
Rick Palechuk
Wizard Member
Posts: 1896
Joined: Wed, May 18 2005, 7:54PM
Company Name: Milltech Millworks Ltd.
Country: CANADA
Location: Edmonton, Alberta
Contact:
Contact Rick Palechuk

Re: Island

Post by Rick Palechuk »

Pete,

You would probably find it easier to create an assembly of cabinets and parts in the CE, and then take that to your room layout.
Top
Wally Schneeberger
Guru Member
Posts: 481
Joined: Tue, May 17 2005, 1:55PM

Re: Island

Post by Wally Schneeberger »

Pete Rafferty wrote:A large island with angled corners, flutes and corbels.
What is the easiest method? Would it be back to back walls and 4 angled set at the correct position. If the walls are not to be seen are they set to 0?

Corbels, flutes, onlays etc ... can some one point me in the right direction?

Thanks
Look here for parts -- http://www.thermwood.com/forums/viewforum.php?f=5 -- and also under Hardware Products and Adams Wood products.
Top
Post Reply

Return to “eCabinet Systems Software”