Terrible problem with Hardware data base

Kerry Fullington · Post by **Kerry Fullington** » Wed, Feb 24 2010, 6:48PM

Upon installing V6 Build 2 I find that my hardware database has not been brought forward.
I had to re-enter all my hardware several times during beta testing and do not want to do it again.

Hopefully I can back out of build 2 and come back to it when it is fixed. It is way too much work to re-enter all my hardware, vendor and distributor info.

Kerry

Gary Campbell · Post by **Gary Campbell** » Wed, Feb 24 2010, 7:39PM

Kerry...
Virtually all my setting etc were carried forward, but like you I lost the hardware. Unlike you, I had only a small number inV6 b1 and will go forward. Hopefully will be fixed before next version. I was luck to get the last of my V5.2 cabinets cut yesterday. Forward with V6!

Bryan J Tanner · Post by **Bryan J Tanner** » Wed, Feb 24 2010, 7:46PM

Kerry

See my post below 'Hardware DB' Josh seems to have a solution

Kerry Fullington · Post by **Kerry Fullington** » Wed, Feb 24 2010, 8:33PM

Bryan,

I had thought of that but I think I will also have to replace the eCabinets.mdb because I also lost all my materials and my doors show the missing image yellow so there must be a problem with the materials files and my irfanview .exe disappeared again (happened in beta testing also) so there seems to be a lot to fix.

I will look at it again tomorrow and everything will be OK.

Kerry

Bryan J Tanner · Post by **Bryan J Tanner** » Wed, Feb 24 2010, 8:37PM

Kerry,

Where do you find those files?

or are they what backing up creates?

Thermwood / eCabinet Systems

Terrible problem with Hardware data base

Terrible problem with Hardware data base

Re: Terrible problem with Hardware data base

Re: Terrible problem with Hardware data base

Re: Terrible problem with Hardware data base

Re: Terrible problem with Hardware data base