Can i create my own molding?

Michael Townes · Post by **Michael Townes** » Fri, Apr 02 2010, 10:52AM

Is there any way to create a molding i can use in the molding editor after creating it using a display cube/board and the part editor? Or a different way?

Kerry Fullington · Post by **Kerry Fullington** » Fri, Apr 02 2010, 12:55PM

Michael,

You can add a molding you create as a Display Object but you can't add it using the Molding Editor.

Michael Townes · Post by **Michael Townes** » Fri, Apr 02 2010, 1:24PM

I was afraid that would be the answer. Sure would make things a lot easier. Thank u for the reply.

Thermwood / eCabinet Systems

Can i create my own molding?

Can i create my own molding?

Re: Can i create my own molding?

Re: Can i create my own molding?