Parasolid Boolean Subtraction Failure

[Donald Thomson]

I'm trying to add a couple of raised panel doors to a cabinet and keep getting a dialog saying:

Failed Door creation

parasolid boolean subtraction failure while coping door bottom rail

This sure seems like one of those error messages that should be reworded for non-programmers (i.e. cabinet makers). It should also give hints as to what to do to solve the problem.

[Kerry Fullington]

Donald,

You might list what door it was and the steps you used to create the error.
Did you try a different door or is it doing this with all doors?
I am sure that error message is for the benefit of the programmers not the user.

Kerry

[Donald Thomson]

Kerry,

I'm working with tech support on this issue. It might go deeper in that the default image for my doors in this particular job are changing without my changing them. When I try to change the image back to what I want I get the meaningless error dialog. I'll let you know what I find out.

[Josh Rayburn]

Donald,
I have had nearly ALL my image patterns change on me without changing them. Even after regen's they appear incorrect. I reported this a while back but I think it was pretty low on the list at the time....
jnr

[Rick Deskins]

Please post a cabinet and list some steps. Not sure exactly what you are talking about.

[Donald Thomson]

Rick,

I'm working with James on this issue right now. I've sent him a couple of cabinets this is happening to along with steps.