Thermwood CabinetShop 43 modeling mdf doors

Duane Marrett · Post by **Duane Marrett** » Fri, Apr 23 2010, 2:50PM

Demonstration of MDF doors being modeled on a Thermwood CabinetShop 43. The doors were created in the Part Editor of eCabinet Systems, and then sent to the CabinetShop 43.

Brad McIntosh · Post by **Brad McIntosh** » Fri, Apr 23 2010, 3:19PM

Duane,

Is there supposed to be a video or link?

Josh Rayburn · Post by **Josh Rayburn** » Fri, Apr 23 2010, 3:35PM

Dude that's some awesome music at the end!

Neville Bastian · Post by **Neville Bastian** » Fri, Apr 23 2010, 9:46PM

Great Video Duane,
Looks like about 9 doors? What was the machine time to do those?
If the client wants some 4 pane glass doors can you design that to match the design shown on youtube? What would be the process time?
Regards
Neville

Brent East · Post by **Brent East** » Mon, Apr 26 2010, 3:11PM

Neville,

These doors were around a 20 minute run time each. That will vary depending on the step over amount set in Profile Modeler. The doors were created in eCabinet Systems through the part editor, so to answer you second question yes you could create a 4 pane glass door. Run time for that would depend on the detail in the styles and rails you make and again the step over distance. Thank you.

Neville Bastian · Post by **Neville Bastian** » Mon, Apr 26 2010, 7:37PM

Thanks Brent,
We have about 25 doors per average kitchen, so we are looking about 8 hrs work.
On a unique style I can justify the time but on a standard pattern where we have the correct shaped router bits in place I will have to continue with my legacy software.

Thanks for the reply
Regards Neville

Thermwood / eCabinet Systems

Thermwood CabinetShop 43 modeling mdf doors

Thermwood CabinetShop 43 modeling mdf doors

Re: Thermwood CabinetShop 43 modeling mdf doors

Re: Thermwood CabinetShop 43 modeling mdf doors

Re: Thermwood CabinetShop 43 modeling mdf doors

Re: Thermwood CabinetShop 43 modeling mdf doors

Re: Thermwood CabinetShop 43 modeling mdf doors