Editing Countertop

[Bryan J Tanner]

Hi

I get the dreaded 'Cannot apply the selected changes: the resulting part would have a non-manifold
body' error when trying to apply a closed contour to a benchtop.

Am i doing something wrong?

[Dan Calvert]

I had this same problem this week trying to add a profile to a countertop. I was using the partial configuration and when I selected the path of the tool in the opposite direction it worked fine. I don't know if this will help you but it solved my problem.

[Joe Dusel]

I noticed the problem as well when I tried to put an edge profile on the bottom side of a countertop.

Joe