Interesting shelf editor picture

Donald Thomson · Post by **Donald Thomson** » Sun, Jul 04 2010, 6:16PM

When trying to add/edit shelves in a corner cabinet I keep getting this interesting rendering. Any ideas? I've attached the cabinet file also.

Matt Snowball · Post by **Matt Snowball** » Mon, Jul 05 2010, 1:32AM

I have had a similar thing happen too .

Nat Wheatley · Post by **Nat Wheatley** » Mon, Jul 05 2010, 3:57PM

Don,

Any chance that cabinet was created in Ver. 5? I had issues, in one way or another, with just about every cabinet I tried to bring into version 6. I chased some of the issues, but for the most part had more success deleting the cabinets and re-building from scratch.

Naturally, disregard this if you created this cabinet in Ver. 6.

Nat

Donald Thomson · Post by **Donald Thomson** » Mon, Jul 05 2010, 4:17PM

Nat,

Thanks for the response. The cabinet is actually one of the seed cabinets I built from scratch in V6. I was going to use it in a design and needed to resize it and that's where all the interesting results start happening. I chucked the cabinet I was working on, brought the seed in again, resized it to what I wanted and life was good. No more problems. Go figure.....

DanEpps · Post by **DanEpps** » Mon, Jul 05 2010, 7:57PM

I had something like this happen years ago with version 4 I think it was. I cleared the Cabinet Editor workspace and was left with the target looking somewhat like a really busy atom (http://www.thermwood.com/forums/viewtop ... f=3&t=4058). I think my problem back then was related to old video drivers or not enough video memory...something like that but it went away.

Thermwood / eCabinet Systems

Interesting shelf editor picture

Interesting shelf editor picture

Re: Interesting shelf editor picture

Re: Interesting shelf editor picture

Re: Interesting shelf editor picture

Re: Interesting shelf editor picture