Draw height clearance dissapers

[Jason Stephenson]

I have Just came across a problem with the draw front height when we put a set of draw fronts on a cabinet we allow 4mm clearance a the top and draw to draw gap is 2mm on ecabs,then when we cut out the draw front and screw them on with the bottom draw front flush with the deck then a 2mm clearence between the draw fronts we only end up with 1.5mm clearance at the top is there any way of fixing this problem? I wasn't quite sure whether it had something to do with the edgebanding?

[Rick Palechuk]

In the Door Drawer Editor hilite the top drawer, right click and go to Construction Settings and set the Top Reveal to 4mm, and click ok. That should fix you up. If your having more problems,then post the hsf file of the cabinet so someone can take a look at it. HTH