Insert line of code at control

Josh Rayburn · Post by **Josh Rayburn** » Fri, Oct 01 2010, 3:40PM

How can I insert a line of code manually when running a program at the control?
For example, a M00 before a tool change or something like that?
jnr

Will Williamson · Post by **Will Williamson** » Sat, Oct 02 2010, 12:53PM

Scroll down the program to where you want to insert the code
press F1 (teach) F5 (insert text) insert your code and press enter
You can even Block Stop and enter code as you are running the program.
Did you attend operator's training school at Thermwood?

Jeremy Schiffer · Post by **Jeremy Schiffer** » Sat, Oct 02 2010, 6:41PM

If you're using a Gen2 controller, it is e then e again to insert a line. (maybe the F keys work for this as well, never tried it.)

Josh Rayburn · Post by **Josh Rayburn** » Mon, Oct 04 2010, 6:56AM

Thanks guys, I'll give it a try today.
jnr

Thermwood / eCabinet Systems

Insert line of code at control

Insert line of code at control

Re: Insert line of code at control

Re: Insert line of code at control

Re: Insert line of code at control