Select the main cabinet (glass doors and drawers)
take the cabinet into the face frame editor
Highlight one of the drawer openings
Look at the opening size
Problem with face frame opening
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
Kerry Fullington
- Wizard Member
- Posts: 4763
- Joined: Mon, May 09 2005, 7:33PM
- Company Name: Double E Cabinets
- Country: UNITED STATES
- Location: Amarillo, TX
Problem with face frame opening
Open the attached assembly in the cab editor
Select the main cabinet (glass doors and drawers)
take the cabinet into the face frame editor
Highlight one of the drawer openings
Look at the opening size
Select the main cabinet (glass doors and drawers)
take the cabinet into the face frame editor
Highlight one of the drawer openings
Look at the opening size
- Attachments
-
- assembly.esa
- (2.32 MiB) Downloaded 273 times
-
Scott G Vaal
- Thermwood Team
- Posts: 1740
- Joined: Tue, May 17 2005, 12:44PM
- Company Name: Thermwood Corporation
- Location: Thermwood Corp: Dale, Indiana
- Contact:
Re: Problem with face frame opening
Kerry,
Not sure why it shows those values. If you just leave the Face Frame editor and then return back in, it will then show correctly. I will pass it over to the programmers and let them examine it. Is this the only cab/assembly you have seen this on?
Not sure why it shows those values. If you just leave the Face Frame editor and then return back in, it will then show correctly. I will pass it over to the programmers and let them examine it. Is this the only cab/assembly you have seen this on?
Regards,
Scott Vaal
-Thermwood/eCabinet Systems-
Dell Precision / Xeon E3-1240 / 8GB RAM /NVIDIA Quadro K2000
Scott Vaal
-Thermwood/eCabinet Systems-
Dell Precision / Xeon E3-1240 / 8GB RAM /NVIDIA Quadro K2000
