So these are already documented but just wanted to give a little reminder. Although 5.59 fixes my flip ops first trim 2 edges offset problem it created a problem with the rampin on outline as well as the flip op trim feature for off falls. Both of these make it hard to stay with 5.59. However in 5.58 I don't have the use of flip ops first or the barbed dado feature which is stalling the release of a new line of cabinets. Hope you guys are on it.
Thanks,
Forrest
Why I need 5.60!
Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein
-
Forrest Chapman
- eCabinets Beta Tester
- Posts: 1253
- Joined: Mon, May 30 2005, 2:26PM
- Location: Anderson SC.
- Contact:
-
Ryan Hochgesang
Re: Why I need 5.60!
Forrest,
I've forwarded your statement of urgency to the appropriate dept. here .... I do know that 5.60 is in the works, I just haven't heard a final release date..
I've forwarded your statement of urgency to the appropriate dept. here .... I do know that 5.60 is in the works, I just haven't heard a final release date..