I just downloaded 5.60 and it creates an error and shuts CN down when i try 2 open RN. I had CN closed when installing it, ive updated the profile molder, im on 5.05 Build 9. Any ideas?
We will need to know exactly what the error is and when the error is occuring (ie: during install, as soon as install finishes etc..). You can try to run the update again and it should remove the update and put back to version prior.
I 've setup a system here with your configuration files and also see that THM software crashes when attempting to open Control Nesting. I have submitted the issue to our engineering dept. for fix. I will keep you up to date.
