Good Afternoon.
Can anybody from Thermwood tell me how do you remove the table ball bearing. I have successfully remove (one by one) the Y and z axis bearings clean and install them today, I want to do the same with the table bearings. Our table have 6 bearings and not 4 like the manual say and it is not just loosen them and slide them off like the manual say either. Our bearing (housing) is connected to a aluminum block that is connected to the table. Loosening the bolts on the top of the table is not working.
Thanks in advance
Marius
Jireh Custom Interriors
C40-482
Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein
-
Marius Gouws
- Junior Member
- Posts: 82
- Joined: Sun, May 14 2006, 4:01AM
- Company Name: Plett Roofing
- Country: SOUTH AFRICA
- Location: Plett, South Africa
- Contact:
-
Ryan Hochgesang
Re: C40-482
Marius,
Please email our service dept. at the following address for additional information regarding removal of bearings:
service@thermwood.com
Please email our service dept. at the following address for additional information regarding removal of bearings:
service@thermwood.com