Image not showing up

[Gary Puckett]

In the define hardware area I am having a hard time getting the image of the hardware to show up. Let me explain It shows up when I first do it but when I close the hardware list down and go back to it the image is not there.

Is anyone else having this problem?

Thanks
Gary

[David Egnoski]

I had this problem a while back. It turns out I had a special character in the name that I gave to the hardware. Something like / & $. Don't know if that's what causing your problem but maybe?

[Gary Puckett]

David,

Thanks that was the problem, I use a drawer slide that requires a locking device and you need a right and a left so when I titled the image I used R/L when I removed the/ everything was fine.

Gary