dims for drawer boxes
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
BenRatt
- Senior Member
- Posts: 170
- Joined: Sat, Oct 22 2005, 10:59AM
- Location: Spartanburg, SC
- Contact:
dims for drawer boxes
Is there any way to get the LDE to snap to dowel/KD holes for a drawer box? I am making doweled drawer boxes and can't confirm the hole pattern. I am having to figure it out with a calculator.
- Attachments
-
- 36w 25_25d 28_5T LRFE.hsf
- (1.1 MiB) Downloaded 396 times
-
Scott G Vaal
- Thermwood Team
- Posts: 1740
- Joined: Tue, May 17 2005, 12:44PM
- Company Name: Thermwood Corporation
- Location: Thermwood Corp: Dale, Indiana
- Contact:
Re: dims for drawer boxes
Ben,
Sorry, currently there is not. I will list it and hopefully markers/nodes for these and PE cut holes will be available in a future release. As an intermediate aid, you could take the dbx parts to the Part Editor, then Contour area. Once there, you can select CreateEdges from the right click menu and use the geometry created and add other lines etc. to help figure some of your values.
Sorry, currently there is not. I will list it and hopefully markers/nodes for these and PE cut holes will be available in a future release. As an intermediate aid, you could take the dbx parts to the Part Editor, then Contour area. Once there, you can select CreateEdges from the right click menu and use the geometry created and add other lines etc. to help figure some of your values.
Regards,
Scott Vaal
-Thermwood/eCabinet Systems-
Dell Precision / Xeon E3-1240 / 8GB RAM /NVIDIA Quadro K2000
Scott Vaal
-Thermwood/eCabinet Systems-
Dell Precision / Xeon E3-1240 / 8GB RAM /NVIDIA Quadro K2000
