edge band editor

Michael S Murray · Post by **Michael S Murray** » Wed, Apr 20 2011, 5:15PM

I am in the drawer box editor and have made a melamine drawer box, when I try to take it to the edge band editor I get a error saying,"This cabinet does not have enough data to edge band its parts"
I have regenerated it, closed e-cabs and restarted, etc..
Never seen this one, any help?????

Wally Schneeberger · Post by **Wally Schneeberger** » Wed, Apr 20 2011, 6:45PM

I could be wrong but I don't think that drawer boxes are supported in the edge banding. Somebody please tell me I'm wrong. LOL.

Kerry Fullington · Post by **Kerry Fullington** » Wed, Apr 20 2011, 7:24PM

Mike,

In the Drawer box Editor double click your drawer box to select it then right click and choose Remove Part Editor cuts from entire drawer box.

Kerry

Michael S Murray · Post by **Michael S Murray** » Thu, Apr 21 2011, 6:23AM

Thanks Kerry, I will try it..
Wally, YOUR WRONG..

I kinda feel like Donald Trump now...

Kerry, that done it!
There were no part editor cuts??

Kerry Fullington · Post by **Kerry Fullington** » Thu, Apr 21 2011, 6:35AM

Mike,

Removing Part Editor Cuts just causes the cabinet or drawer box to re-generate. The bad part is that if you had Part Editor cuts on the box you would have to redo them.

Be sure to save the re-generated box to your files.

Gary Campbell · Post by **Gary Campbell** » Thu, Apr 21 2011, 6:35AM

Kerry...
I have some existing commercial draw baxes that have a number of PE cuts in them. Do I have to remove them and then reapply and constrain them so that EB quantities will be accurate? I am talking about the 2 notches and holes in the back for BLUM Tandem and Draw Front mounting holes in the front. Please say it isnt so.

Kerry Fullington · Post by **Kerry Fullington** » Thu, Apr 21 2011, 6:39AM

Gary,

I think the edgebanding quantity problem is a different bug. There is a thread about this somewhere. I'll see if I can find it. I wouldn't do anything about that unil the next release. Maybe the new release will fix that.

Josh Rayburn · Post by **Josh Rayburn** » Thu, Apr 21 2011, 8:42AM

From my experience, the drawer box losing part bodies (hence the error about edgebanding it) was spotty, it didn't happen to all my drawer boxes just some of them. But as Kerry said, when you get the error "removing part editor cuts" rebuilds the part bodies and all is well......as long as there's no notches etc. to redo!
jnr

Wally Schneeberger · Post by **Wally Schneeberger** » Thu, Apr 21 2011, 9:48AM

Michael S Murray wrote: Wally, YOUR WRONG..

Thanks Mike !!!

Thermwood / eCabinet Systems

edge band editor

edge band editor

Re: edge band editor

Re: edge band editor

Re: edge band editor

Re: edge band editor

Re: edge band editor

Re: edge band editor

Re: edge band editor

Re: edge band editor