Hey guys, not sure where the problem is but the part is created in ecabs with a display board and I also tried a face frame part to no avail. When I load this file in CN it is empty. Nothing shows up.
Forrest
Empty file in CN
Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein
-
Forrest Chapman
- eCabinets Beta Tester
- Posts: 1260
- Joined: Mon, May 30 2005, 2:26PM
- Location: Anderson SC.
- Contact:
Empty file in CN
- Attachments
-
- DB ash part.zip
- (132.17 KiB) Downloaded 452 times
-
- DB ash part.esa
- (74.02 KiB) Downloaded 329 times
-
Daniel Vonderheide
- Thermwood Team
- Posts: 361
- Joined: Wed, May 17 2006, 11:25AM
- Location: Thermwood
Re: Empty file in CN
Display boards and board stock are not nested. Only display panels and sheet stock are nested.
