Corner Cab Bug

[Wally Schneeberger]

Here is a cabinet that I changed the corner settings on and it shows the change but when I take the top to PE it still shows a mitered corner and I cannot do what I wanted to do -- 7.5" x 7.5" corner cutout.

f&g.hsf

(410.02 KiB) Downloaded 1067 times

f&g.jpg (12.98 KiB) Viewed 12807 times

[Kerry Fullington]

Wally,

Your cabinet seems to work as it should.

Are you talking about the miter on the front of the cabinet or the back?

[Wally Schneeberger]

At the back Kerry-- I don't want any miter there but it keeps it even when I change it. I want a square of 7.5" cut from the corner (to go around a post) not a miter.

[George Davidson]

Hi Wally
Is this what you are looking for

[Kerry Fullington]

Wally,

Your cabinet works fine for me.

Try opening the cabinet in the cab editor then right click and choose Remove Part Editor Cuts/From Entire Cabinet and let the cabinet re-generate and see if you can get it to work in the part editor.

[George Davidson]

Here is one for you Kerry
I will have to try that

[Wally Schneeberger]

Hi Wally
Is this what you are looking for

That's it George -- I guess I will have to regenerate it like Kerry advises to get it right.
Thanks George.

[Wally Schneeberger]

Wally,

Your cabinet works fine for me.

Try opening the cabinet in the cab editor then right click and choose Remove Part Editor Cuts/From Entire Cabinet and let the cabinet re-generate and see if you can get it to work in the part editor.

Thanks Kerry - I must have lingering PE cuts.