Need program for parts which are beyond my experience and software capabilities.
These four parts have strict deadline so I am hoping I could hire one of you to write the cnc program for my CS 43.
The problem is carving the area where two cove molding shapes make an inside corner.
I have attached a picture of the type of look I want. Also is attached a 2d dxf drawing.
Need four parts double sided, (2) 5 x 56 and (2) 5 X 66.
If you can help me out with this please call with cost, and time. 973-224-0221
Thank you,
JIm
Program needed
Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein
-
Jim Carter
- Junior Member
- Posts: 64
- Joined: Mon, Nov 30 2009, 3:51PM
- Company Name: Jim Carter Corp.
Program needed
- Attachments
-
- lft half 113zip.zip
- (512.3 KiB) Downloaded 562 times
-
