Thought this had been fixed during beta process

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Post Reply
Donald Thomson
Guru Member
Posts: 833
Joined: Thu, May 14 2009, 11:41PM
Company Name: Diamond Lake Custom Woodworks
Location: Newport, WA
Contact:
Contact Donald Thomson

Thought this had been fixed during beta process

Post by Donald Thomson »

Part exists but is not being nested error on the attached cabinet.
Attachments
VR36.28.21.2.4.hsf
(2 MiB) Downloaded 245 times
Part exists but wont nest.jpg
Sincerely,

Don Thomson
Diamond Lake Custom Woodworks, LLC
509-671-6230
Newport, WA
http://www.dlwoodworks.com
Top
User avatar
Scott G Vaal
Thermwood Team
Posts: 1740
Joined: Tue, May 17 2005, 12:44PM
Company Name: Thermwood Corporation
Location: Thermwood Corp: Dale, Indiana
Contact:
Contact Scott G Vaal

Re: Thought this had been fixed during beta process

Post by Scott G Vaal »

Don,

This issue is fixed. You must regen this cabinet and then save it to resolve this old issue. This fixed it for me...
Regards,

Scott Vaal
-Thermwood/eCabinet Systems-
Dell Precision / Xeon E3-1240 / 8GB RAM /NVIDIA Quadro K2000
Top
Post Reply

Return to “eCabinet Systems Software”