Cut through depth added to chain

[Josh Rayburn]

It appears that the last couple of lines on the first chain operations to occur are getting the cut-through depth added. I can't figure out why.
First chain operation in the code goes from .735 to .740"
Not a huge problem for this job but I can see it biting me later.....
Any additional info needed, please let me know.
Thanks
jnr

[Josh Rayburn]

Actually on closer inspection the second group of chain operations also seem to have an odd combination of Z values.
Perhaps this is because the vectors for the first pass are identical to (and share vertices with) the second pass?
Is CN getting confused from this?

[Daniel Vonderheide]

josh,

email me the export from your machine with this job loaded. I will look into it. Program@Thermwood.com

[Josh Rayburn]

Daniel, did you ever look into this by any chance?
Just got bit again. I'm assuming that since the original post was a while ago, I actually did send a sample file(s) as requested, but who knows......I have an old "hard drive" in my knot and it don't quite spin up like it used to....
jnr

[Daniel Vonderheide]

I never received the files requested. Please send the most recent files to program@thermwood.com along with information on the issue. This way, if I am not the tech that looks at it, they will know what they are looking for.

[Larry Epplin]

Hi Josh. We ran across this issue working on another problem. It should be resolved for the next update of Control Nesting.

[Josh Rayburn]

Thanks Larry, much appreciated.
jnr