RNestWithPF error

[Conrad Du Plessis]

Hi everyone,

I need some urgent help.
Trying to nest we got the following message:

RNestWithPF

Internal application error.

The Thermwood CNC was working fine on the job moments before this error. Now we can can not nest at all. We are updated to V5.71. I have uninstalled and re-installed this version 3x . I have also "downgraded" to v5.68 with no luck, and upgraded to v5.71 again. However, the problem remains !

Any help would be highly apreciated !

Conrad Du Plessis
Johannesburg
South Africa

[Brad McIntosh]

Conrad,

Just thought I would mention that this forum is NOT the direct link to Thermwood's support people.

If you have not done so already, you may want to send this software issue information and request to: program@thermwood.com


Good luck...