Wondering if there is a post processor selection in VCarve Pro that would work best with a cs43.
Thanks for any help
Post Processor using V Carve on a CS43
Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein
-
Alex Ferrec
- New Member
- Posts: 2
- Joined: Tue, Feb 25 2014, 5:09PM
- Company Name: Rylex
- Country: UNITED STATES
-
jason galbraith
- Senior Member
- Posts: 249
- Joined: Wed, Dec 10 2008, 3:29PM
- Company Name: Eastcoast Ultimate
- Country: AUSTRALIA
- Contact:
Re: Post Processor using V Carve on a CS43
Search.
http://www.thermwood.com/forums/search. ... rds=vcarve
We run a CS40 you'll find a good post processor in one of these threads.
Try looking at
http://www.thermwood.com/forums/viewtop ... rve#p69489
http://www.thermwood.com/forums/search. ... rds=vcarve
We run a CS40 you'll find a good post processor in one of these threads.
Try looking at
http://www.thermwood.com/forums/viewtop ... rve#p69489
Core i7-2600 @ 3.70Ghz - 8 GB ram - Win 7 Ultimate 64bit - 2 x 24" ASUS monitors - Nvidia 600 Quadro 1GB graphics
www.eastcoastultimate.com.au
www.eastcoastultimate.com.au
-
Alex Ferrec
- New Member
- Posts: 2
- Joined: Tue, Feb 25 2014, 5:09PM
- Company Name: Rylex
- Country: UNITED STATES
Re: Post Processor using V Carve on a CS43
Thanks for the response. I realized that with the demo version of V Carve, I can't upload the post processor. I want to see if something could get cut out using this software. I tried loading the .nc file but there are no parts listed on the controller. I don't know if this is possible, but if someone could send me a small .nc toolpath file with the edited post processor that would work with a CS43 that would be really helpful. That way I could dry run the file on the CNC. Again, I just want to see if the machine will run something because I am looking to purchase V Carve.
