This is the most evident when cutting dovetail drawers. In most cases we have it set smallest to largest because of the mix of drawer sizes. The initial skin pass would run so much faster if it ignored the outline setting and made the shortest moves. Ironically this seems to be the way the rest of the operations work.
Forrest
Need a small change to "cut small to large" setting
Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein
-
Forrest Chapman
- eCabinets Beta Tester
- Posts: 1260
- Joined: Mon, May 30 2005, 2:26PM
- Location: Anderson SC.
- Contact:
