It is pretty obnoxious when you have several drawers in a cabinet that each time you make the smallest changes it takes about 3 seconds to regenerate each dbx's in a cabinet, even if you haven't made any changes that will effect dbx's. This might not seem like much but when you are refining a cabinets construction and you have to wait 20 to 30 seconds each time you make a small change it can take 30 minutes to design a cabinet where it should only take about 5 to 10 minutes. Over the course of a house full of cabinets, this can take a 2 hour design session and easily turn it into an all day design session (waist of time).
Is there a way to or can a way be implemented - to turn off dbx regeneration every time I sneeze. It makes cabinet design time PAINFULLY long winded, like reading Gone With The Wind. Right now I just go to another program for a couple of minutes while a cabinet gets regen'd.
