but it ran fine. What am I doing wrong?No Material Images or Pulls with build 13?
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
George L Vought
- Junior Member
- Posts: 85
- Joined: Fri, Feb 16 2007, 2:00PM
No Material Images or Pulls with build 13?
I Just downloaded the V6 build 13. Fired it up to give it a run. When I went to set my materials and pulls preferences I got a No Image box?? When I went into my eCab program files I didn't see any of the folders that used to be in there before. I had an old setup for the pulls and materials so I ran that. It put the files into my documents instead of the eCab folder? I tried moving them manually into the program but I still can't get it to work? I already uninstalled the previous build (ashamed to say it was build but it ran fine. What am I doing wrong?
but it ran fine. What am I doing wrong?The only DUMB question is the one you don't ask!
-
George L Vought
- Junior Member
- Posts: 85
- Joined: Fri, Feb 16 2007, 2:00PM
Re: No Material Images or Pulls with build 13?
Problem solved
Finally figured it out. It's taking awhile but, I'm getting the hang of it again.
Finally figured it out. It's taking awhile but, I'm getting the hang of it again.
The only DUMB question is the one you don't ask!
