Hi, I am having a problem in the tool operation I am trying to machine a cabinet using Hafele Rafix KD/RTA and I have the special tool with the spur on from hafele and I can not seem to get the machine to recognize this and the 5mm drill I need for the male stud, is there any one setup using the Hafele Rafix System.
Cheers Stephen
KD/RTA SETUP
Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein
-
Stephen Tinkler
- Junior Member
- Posts: 85
- Joined: Thu, Aug 16 2007, 4:20AM
- Location: County Durham, United Kingdom
-
Forrest Chapman
- eCabinets Beta Tester
- Posts: 1260
- Joined: Mon, May 30 2005, 2:26PM
- Location: Anderson SC.
- Contact:
Re: KD/RTA SETUP
I assume you are working in metric so just for starters make sure you have the diameters set up correctly in ecabs and control nest. In control nest/tool setup make sure you have selected the "drill" check box. In control nest/parameters make sure you have the box checked in the bottom left hand. It say something like run arc or line as a drill when on the edge of part. That should get you going.
As a side note I add .05 inches to the daylight value of the rafix bit to account for the brad point tip. I also turn at 10k rpm and plunge at 100 ipm.
Forrest
As a side note I add .05 inches to the daylight value of the rafix bit to account for the brad point tip. I also turn at 10k rpm and plunge at 100 ipm.
Forrest
-
Stephen Tinkler
- Junior Member
- Posts: 85
- Joined: Thu, Aug 16 2007, 4:20AM
- Location: County Durham, United Kingdom
Re: KD/RTA SETUP
Cheers Forrest 
