new tool
Moderators: Jason Susnjara, Clint Buechlein, Jason Susnjara, Clint Buechlein
-
nick staub
- Junior Member
- Posts: 25
- Joined: Mon, Mar 31 2014, 8:31AM
- Company Name: mcmanus dev
- Country: UNITED STATES
new tool
we recently purchased 3 1/2 inch vortex bit part #1685 3/4 dia.what is recommended spindle speed and feed rate etc. for this bit???
-
David Egnoski
- Senior Member
- Posts: 209
- Joined: Tue, May 17 2005, 1:05PM
- Company Name: Richmond Cabinet
- Country: UNITED STATES
- Location: Delavan, WI
Re: new tool
The staff @ Vortex are your best resource for the answer to your question. They've never steered me wrong.
It's all about chip loading and what type of material you're cutting.
It's all about chip loading and what type of material you're cutting.
Dave Egnoski
Richmond Cabinet & Millwork
Richmond Cabinet & Millwork
-
Brad McIntosh
- Guru Member
- Posts: 539
- Joined: Wed, May 18 2005, 6:59PM
- Company Name: CNC Automation
- Country: CANADA
- Location: St. Zotique, Québec, Canada
- Contact:
Re: new tool
Nick,
The title of this forums may be a little misleading... I believe it was meant for the sharing of "Tool Profiles" defined within eCabinet Systems with the Profile Editor and not so much for actual tooling specifications, etc.
I suggest that you re-post your question over in the "Thermwood 3-Axis Machinery" forum. You will probably get more responses there.
http://www.thermwood.com/forums/viewforum.php?f=7
Cheers!
The title of this forums may be a little misleading... I believe it was meant for the sharing of "Tool Profiles" defined within eCabinet Systems with the Profile Editor and not so much for actual tooling specifications, etc.
I suggest that you re-post your question over in the "Thermwood 3-Axis Machinery" forum. You will probably get more responses there.
http://www.thermwood.com/forums/viewforum.php?f=7
Cheers!
