And the single-pass dado is a nice surprise too... MUCH faster.
Kudos to Thermwood!
Don't gimme any lip!
Moderators: Jason Susnjara, Jason Susnjara
-
Jeremy Schiffer
- eCabinets Beta Tester
- Posts: 1149
- Joined: Tue, May 10 2005, 9:36PM
- Company Name: Corlane Custom Cabinetry LLC
- Country: UNITED STATES
- Location: Carnesville, GA
- Contact:
Don't gimme any lip!
...and there is NONE on double-pass parts anymore! With CN 5.79, the new "climb 1st pass, conventional 2nd pass" feature for double pass parts has completely eliminated that annoying little lip that was always left. Now, the small parts have just as nice an edge as the large ones. Awesome.
And the single-pass dado is a nice surprise too... MUCH faster.
Kudos to Thermwood!
And the single-pass dado is a nice surprise too... MUCH faster.
Kudos to Thermwood!
http://www.corlanecabinetry.com
AMD Ryzen 5 7600X 6-Core Processor 4.70 GHz, 64GB RAM, NVidia RTX A2000 12GB, Windows 10 64 bit
CS-41 4x8
CS-45 5x12
AMD Ryzen 5 7600X 6-Core Processor 4.70 GHz, 64GB RAM, NVidia RTX A2000 12GB, Windows 10 64 bit
CS-41 4x8
CS-45 5x12
-
Bryan Sullivan
- New Member
- Posts: 12
- Joined: Fri, Oct 15 2010, 9:05AM
- Company Name: Rylex Closet Systems
Re: Don't gimme any lip!
Finally got to install CN5.79, and love the new double cut feature! In my book this is the best improvement since combining flip ops. No more recutting drawer parts that moved or sanding off the "lip" on small parts. Thanks Thermwood!