Good morning,
From time to time it would be nice to pick up the phone and call someone to discuss a technique issue or what ever. I do not want to infringe on peoples privacy or time so can anyone suggest whether this is approprite and if so what would be proper protocol in order to place a call send an Email etc. or direct me to that portion of this forum that addresses this. Thankyou in advance.
protocol
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
Ralph Balanik
- Senior Member
- Posts: 198
- Joined: Fri, Jul 30 2010, 5:33PM
- Company Name: Ralph Balanik
- Country: CANADA
-
Brad McIntosh
- Guru Member
- Posts: 539
- Joined: Wed, May 18 2005, 6:59PM
- Company Name: CNC Automation
- Country: CANADA
- Location: St. Zotique, Québec, Canada
- Contact:
Re: protocol
Ralph,
As you are a Canadian user you can contact us here at CNC Automation and we can try and assist you.
---------------------------------------------------------------------------------------
Software Support Questions??
Email us at software@cncautomation.com
or
Call us @ 1-800-421-5955 and ask to speak
with a software support representative.
----------------------------------------------------------------------------------------
As you are a Canadian user you can contact us here at CNC Automation and we can try and assist you.
---------------------------------------------------------------------------------------
Software Support Questions??
Email us at software@cncautomation.com
or
Call us @ 1-800-421-5955 and ask to speak
with a software support representative.
----------------------------------------------------------------------------------------
