I think that control nest is not compensating properly for the amount it trims off the sheet. In my case .05" and the parts with tenon cuts as a flip are not lining up with the outline cutter by that amount. I haven't test on my end yet but thought that it may be known already. I'm going to run a test with a larger trim amount and see if it affects it.
Forrest
Flip ops first problem
Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein
-
Forrest Chapman
- eCabinets Beta Tester
- Posts: 1260
- Joined: Mon, May 30 2005, 2:26PM
- Location: Anderson SC.
- Contact:
-
Brad McIntosh
- Guru Member
- Posts: 539
- Joined: Wed, May 18 2005, 6:59PM
- Company Name: CNC Automation
- Country: CANADA
- Location: St. Zotique, Québec, Canada
- Contact:
Re: Flip ops first problem
Forrest,
Are we to assume that you are using the latest Control Nesting 5.89?
Are we to assume that you are using the latest Control Nesting 5.89?
-
Forrest Chapman
- eCabinets Beta Tester
- Posts: 1260
- Joined: Mon, May 30 2005, 2:26PM
- Location: Anderson SC.
- Contact:
Re: Flip ops first problem
Yes, I will run a test later today.
Forrest
Forrest
