I have a few top stretchers that just will not nest. I get the No Current Record error displayed. Any idea what might be the matter with them? The forum would not let me attach the dxfs so here is a link to the folder they are in. The DXF parts list file is attached.
https://www.dropbox.com/sh/mk3v5yd1ok5e ... wPCpa?dl=0
DXFs Won't Nest. No Current Record error displayed
Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein
-
Kyle Koehn
- New Member
- Posts: 15
- Joined: Tue, Jun 14 2016, 6:01PM
- Company Name: Countryside Cabinet Shop
- Country: UNITED STATES
DXFs Won't Nest. No Current Record error displayed
- Attachments
-
- CncRun64.txt
- (1.93 KiB) Downloaded 910 times
-
Brad McIntosh
- Guru Member
- Posts: 539
- Joined: Wed, May 18 2005, 6:59PM
- Company Name: CNC Automation
- Country: CANADA
- Location: St. Zotique, Québec, Canada
- Contact:
Re: DXFs Won't Nest. No Current Record error displayed
Kyle,
I took a look at them and it seems there is something particular to the "F" operations - the geometry associated with the "r64f####.dxf" files.
Just to check.. In the MACHINE CATALOG - Do you have the the following settings?
DXF - Geometry
I took a look at them and it seems there is something particular to the "F" operations - the geometry associated with the "r64f####.dxf" files.
Just to check.. In the MACHINE CATALOG - Do you have the the following settings?
DXF - Geometry
- Break Polylines... YES
- Rectangles for Sides... NO
- Apply Depths to Outlines.... NO
- Set Base of Board... NO
- Set Bottom Edge as... YES
-
Clint Buechlein
- Thermwood Team
- Posts: 786
- Joined: Fri, May 15 2015, 1:21PM
- Company Name: Thermwood Corp
- Country: UNITED STATES
Re: DXFs Won't Nest. No Current Record error displayed
We are looking into it Kyle
-
Kyle Koehn
- New Member
- Posts: 15
- Joined: Tue, Jun 14 2016, 6:01PM
- Company Name: Countryside Cabinet Shop
- Country: UNITED STATES
Re: DXFs Won't Nest. No Current Record error displayed
Brad-
Yes all those settings match what we have set up in the machine catalog.
We ran a whole job and it worked fine. Then we made some changes to our construction method to nearly eliminate all back sided operations. Now the few double sided operations that are left don't seem to work at all. I have looked at it from every angle I can and tried every scenario I can think of and I'm out of options. If I change the blind dado to a rabbet so that it changes to just a 1 sided operation it works and will nest but otherwise, no go.
Yes all those settings match what we have set up in the machine catalog.
We ran a whole job and it worked fine. Then we made some changes to our construction method to nearly eliminate all back sided operations. Now the few double sided operations that are left don't seem to work at all. I have looked at it from every angle I can and tried every scenario I can think of and I'm out of options. If I change the blind dado to a rabbet so that it changes to just a 1 sided operation it works and will nest but otherwise, no go.
