labels

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein

Post Reply
Dave Burtchell
Junior Member
Posts: 98
Joined: Thu, Jun 30 2005, 10:04PM

labels

Post by Dave Burtchell »

Can I use the edge bander marks on labels with Rhino or is that only available with eCabinets?

With the Qcore upgrade, does a c40 then become a "smart router"?

Dave
Top
Post Reply

Return to “Thermwood 3-Axis Machinery”