I'm trying to create a pilot hole in the front of my drawer box for attaching drawer fronts. I've got a 5mm hole that is placed 1/2 an inch from the left(and right) of the edge of the drawer box, I'm trying to develop a constraint that will drill the hole in the horizontal center so no matter the height of my drawer box the hole will be in the center. When i try to add formula h/2 it simply deletes my hole.
constraint deletes hole
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Junior Member
- Posts: 26
- Joined: Thu, Jan 02 2014, 5:46PM
- Company Name: Northwest Kitchen Centre
- Country: CANADA
-
- Guru Member
- Posts: 322
- Joined: Thu, Nov 29 2007, 5:18PM
- Company Name: Tim Lucas Custom Woodworks LLC
- Country: UNITED STATES
- Location: bell, florida
- Contact:
Re: constraint deletes hole
I just tried it on one of my cabinets and it worked fine. resized the drawer and it re-centered the hole.
can you post what you are working on?
Tim
can you post what you are working on?
Tim
Tim Lucas Custom Woodworks LLC
www.TLCW.us
www.TLCW.us
-
- Junior Member
- Posts: 76
- Joined: Fri, Feb 15 2013, 5:21PM
- Company Name: Millworx
- Country: CANADA
Re: constraint deletes hole
Try using the formula "w/2". The drawer face is rotated 90' in the pic
-
- eCabinets Beta Tester
- Posts: 1238
- Joined: Mon, May 30 2005, 2:26PM
- Location: Anderson SC.
- Contact:
Re: constraint deletes hole
Marcel, my drawers are done this way too. Its possible you may have a graphics issue. If you rebuild the drawer after making the constraints does the hole show up?
Ian is correct too that it should be w/2.
Forrest
Ian is correct too that it should be w/2.
Forrest
-
- Junior Member
- Posts: 26
- Joined: Thu, Jan 02 2014, 5:46PM
- Company Name: Northwest Kitchen Centre
- Country: CANADA
Re: constraint deletes hole
I will try using w/2, never considered that, brain wired wrong