Machining plam on 1 1/2'' particle board
Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein
-
DanFecteau
- eCabinets Beta Tester
- Posts: 278
- Joined: Tue, May 10 2005, 12:00PM
- Location: St-Odilon, Quebec, Canada
- Contact:
Machining plam on 1 1/2'' particle board
I have 160 vanities to produce and they are mostly made of 1 1/2'' thick particle board with plastic laminate on both sides. I was wondering what tool do you guys use, feed, rpm, etc.... I've had bad results in the past, only able to cut couple sheets before having bad quality cuts...
-
Thomas strembitsky
- Guru Member
- Posts: 307
- Joined: Fri, Jul 27 2012, 12:30PM
- Company Name: true form cabinets
- Country: CANADA
- Contact:
Re: Machining plam on 1 1/2'' particle board
that sounds like a fun project.... I would use a half inch compression and do it in either two or three passes.
Intel(R) Core(TM) i-13700K @ 2.70GHz 32.00 GB RAM
Windows 11 Professional 64-bit
http://www.trueform.ca
CS43 cnc
Windows 11 Professional 64-bit
http://www.trueform.ca
CS43 cnc
-
Ian Richardson
- Junior Member
- Posts: 81
- Joined: Fri, Feb 15 2013, 5:21PM
- Company Name: Millworx
- Country: CANADA
Re: Machining plam on 1 1/2'' particle board
Make sure your flute length is long enough to cut 1 1/2"
