Adj shelf holes in corner cab

[andy photenas]

Hi all, I am working on tuning up a library for CnC work. I have made my plywood parts in my shop the old way the best I know how.
My question to you all is this, Do you only need a total of 3 sets of adj shelf holes in a corner cab? I have always put 2 in the left side and 2 in the right side then one line in the cut corner piece in the back.
In the free library i downloaded the both cabinets in the one i am trying to use only show 1 set left side 1 set right side and 1 back.
So does that mean that just the 3 sets is the way to go like how it is in the library?

[tim lucas]

Andy,
Three holes would work as long as you use the shelf clips so they hold the top of the shelf. But myself I use 5 holes even with the clips.

Tim

[andy photenas]

I feel the same way about it. My next question would be how do you get a corner cab with that layout ? I tried in shelf/part editor but i cant seem to get it to come out with 5 holes. Can anyone advise me in this ?

[tim lucas]

Post your corner cabinet if you can

[tim lucas]

Better yet, look at the settings in this pic, notice we have all three colums checked to apply holes, on the right side I gave the back holes a negitive number (-3) so it would put the holes off the part and they would not show up. Set your cabinet to these settings and then take a look and see if that is what you are wanting.