Last line feed speed

Dave Burtchell · Post by **Dave Burtchell** » Tue, Jan 10 2006, 6:30PM

Howdy,

I'm using 4.86. I have Last line feed speed set to 300. Outline tool feed speed is 800. I've been getting a lot of parts with the last line feed speed of 800. Anyone else seeing this?

Dave

Ryan Hochgesang · Post by **Ryan Hochgesang** » Wed, Jan 11 2006, 11:44AM

Hi Dave,

Go into your Control Nesting SETTINGS and check to see what the \"Min Feed Rate\" (Located two down from \"Last line feed speed\" )is. I'm guessing that it says 800. This setting will be the slowest feed allowed to be posted in cnc program.

Ryan Hochgesang · Post by **Ryan Hochgesang** » Wed, Jan 11 2006, 11:45AM

Hi Dave,

Go into your Control Nesting SETTINGS and check to see what the \"Min Feed Rate\" (Located two down from \"Last line feed speed\" )is. I'm guessing that it says 800. This setting will be the slowest feed allowed to be posted in cnc program.

Ryan Hochgesang · Post by **Ryan Hochgesang** » Wed, Jan 11 2006, 11:46AM

Sorry about the double reply.

Mouse got stuck I guess

Dave Burtchell · Post by **Dave Burtchell** » Wed, Jan 11 2006, 5:02PM

Ryan,

Min feed rate is set at 100!

Dave

Ryan Hochgesang · Post by **Ryan Hochgesang** » Thu, Jan 12 2006, 9:42AM

Dave,

Try updating to the latest version 4.87 and see if you are still seeing the issue. I had posted a program through 4.87 and it looked good. If you still see the issue, please sent me the file that you are nesting along with the following files from your machine:

C:\\RollingNest\\machine.ini
C:\\RollingNest\\tools.thm
C:\\system\\toolman.thm

Dave Burtchell · Post by **Dave Burtchell** » Sat, Mar 25 2006, 9:45AM

Ryan

Thanks to you and your team for the 4.90 fix of the \"last line feed speed\" problem. Would you please revisit it again and look at the next to last line? I'm seeing 800 ipm showing up there instead of the last line.

Thanks,
Dave

Ryan Hochgesang · Post by **Ryan Hochgesang** » Mon, Mar 27 2006, 4:33PM

Hi Dave,

I will make up some sample files to try and see this issue. I'll get back to you asap.

Ryan Hochgesang · Post by **Ryan Hochgesang** » Tue, Mar 28 2006, 10:48AM

Hi Dave,

I've tried to reproduce the situation that you are explaining, but have been unable to do so. The only thing that I might add, I've been testing in V4.91, this may be the difference. If you still see the issue after updating to v4.91, I would like to see the following files:

- .hsf (cabinet file) or .esa (Assembly file)
- .twd file that you are using from ecab
- .cnc file that you've generated at CNC machine
- C:\\RollingNest\\machine.ini (From Thermwood Controller)
- C:\\RollingNest\\tools.thm (From Thermwood Controller)
- C:\\System\\Toolman.thm (From Thermwood Controller)

Thermwood / eCabinet Systems

Last line feed speed

Last line feed speed