Hi,
I'm trying to find the document where it shows all the name of layers we can use with Autocad. I already fund it in the past but I don't know where to look anymore.
I know there is a way to have a ''start point'' with the layer but can't remember how.
Thank you!
Layers
Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein
-
Audrey Racine
- eCabinets Beta Tester
- Posts: 164
- Joined: Tue, May 17 2005, 6:31AM
- Location: Canada, Quebec city
-
David Egnoski
- Senior Member
- Posts: 209
- Joined: Tue, May 17 2005, 1:05PM
- Company Name: Richmond Cabinet
- Country: UNITED STATES
- Location: Delavan, WI
Re: Layers
Go to the link below and open the Control Nesting Manual. Go to page 93 and you'll find the layer names.
Hope this helps you out.
http://www.thermwood.com/software_manuals_main.htm
Hope this helps you out.
http://www.thermwood.com/software_manuals_main.htm
Dave Egnoski
Richmond Cabinet & Millwork
Richmond Cabinet & Millwork
-
Brad McIntosh
- Guru Member
- Posts: 539
- Joined: Wed, May 18 2005, 6:59PM
- Company Name: CNC Automation
- Country: CANADA
- Location: St. Zotique, Québec, Canada
- Contact:
Re: Layers
Audrey,
We have a PDF document that covers the DXF layer names, etc. Please send us an email at software@cncautomation.com and we will send you the most recent version of the document.
Nous avons un document PDF décrivant les noms des couches DXF, etc. Envoyez-nous un courrier électronique à l'adresse logiciel@cncautomation.com. Nous vous enverrons la version la plus récente du document.
We have a PDF document that covers the DXF layer names, etc. Please send us an email at software@cncautomation.com and we will send you the most recent version of the document.
Nous avons un document PDF décrivant les noms des couches DXF, etc. Envoyez-nous un courrier électronique à l'adresse logiciel@cncautomation.com. Nous vous enverrons la version la plus récente du document.
