Sets in Constraints editor

[Mark McCallum]

I had a quick dig around and couldn't find anything.
So I thought I'd ask the collective Ecabs mind.

Once you create a set in the Constraints Manager, can you uncreate it to re-edit? I was trying to change diameters and don't think I can ungroup it?
Also can you copy and paste sets within the CM, I tried a few ways but I don't think so. Just looking for confirmation?

Any feed back appreciated.
Thanks
Mark

[Clint Buechlein]

Mark,

To undo a Set, choose the delete like you would to do a dimension and then select the set icon (the green S with the green circle on it). That will ungroup them from a set, you can make your changes and recreate the set.

-Clint-

[Mark McCallum]

Thanks Clint.
That makes sense.