It is sticking up by 100mm, half the actual specified distance. And the end has descended by 100mm which should be flush?
putting insets of 100mm top and bottom of the end rectifies the settings
- aaa.jpg (16.09 KiB) Viewed 5587 times
Mark
Left end construction setting
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
Mark McCallum
- Guru Member
- Posts: 563
- Joined: Thu, Jun 16 2005, 7:53PM
- Location: Sydney Aust
Left end construction setting
Its probably just me, but in the attached, the top inset is set to 200mm, left side top flush and left back flush.
It is sticking up by 100mm, half the actual specified distance. And the end has descended by 100mm which should be flush?
putting insets of 100mm top and bottom of the end rectifies the settings Thanking you
Mark
It is sticking up by 100mm, half the actual specified distance. And the end has descended by 100mm which should be flush?
putting insets of 100mm top and bottom of the end rectifies the settings Thanking you
Mark
- Attachments
-
- aaa.hsf
- (1.44 MiB) Downloaded 513 times
-
Clint Buechlein
- Thermwood Team
- Posts: 785
- Joined: Fri, May 15 2015, 1:21PM
- Company Name: Thermwood Corp
- Country: UNITED STATES
Re: Left end construction setting
Mark,
You're supposed to find this stuff before release
. In theory it should work, though I've never tried something like this before. I've got it repeating a standard cabinet, so I'll send it to the software engineers.
-Clint-
You're supposed to find this stuff before release
. In theory it should work, though I've never tried something like this before. I've got it repeating a standard cabinet, so I'll send it to the software engineers. -Clint-
-
Mark McCallum
- Guru Member
- Posts: 563
- Joined: Thu, Jun 16 2005, 7:53PM
- Location: Sydney Aust
Re: Left end construction setting
If only things behaved the way they are supposed to.
Life would be much simpler.
Job Done
Life would be much simpler.
Job Done
