I think I know what the problem is but I just thought I would ask.
As you can see by my pic. x axis is off. Drive belts are still in tact.
Wont come out of e stop
Thermwood c43
X axis out
Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein
-
Ian Richardson
- Junior Member
- Posts: 81
- Joined: Fri, Feb 15 2013, 5:21PM
- Company Name: Millworx
- Country: CANADA
-
Ian Richardson
- Junior Member
- Posts: 81
- Joined: Fri, Feb 15 2013, 5:21PM
- Company Name: Millworx
- Country: CANADA
-
Clint Buechlein
- Thermwood Team
- Posts: 785
- Joined: Fri, May 15 2015, 1:21PM
- Company Name: Thermwood Corp
- Country: UNITED STATES
Re: X axis out
If you go to Maintenance, PLC, PLC Screen, what reason does it say for estop? You can press NC Reset to clear the screen to see what errors are persistent in the event something else was in there that has been corrected.
-Clint-
-Clint-
-
Ian Richardson
- Junior Member
- Posts: 81
- Joined: Fri, Feb 15 2013, 5:21PM
- Company Name: Millworx
- Country: CANADA
Re: X axis out
Yes. Have to remember to check plc history 
turns out it was a pop up pin. Thanks to Simon @ CNC Automation. Resolved
Thanks for the reply though Clint
turns out it was a pop up pin. Thanks to Simon @ CNC Automation. ResolvedThanks for the reply though Clint
-
Clint Buechlein
- Thermwood Team
- Posts: 785
- Joined: Fri, May 15 2015, 1:21PM
- Company Name: Thermwood Corp
- Country: UNITED STATES
Re: X axis out
Glad you were able to get it fixed.Ian Richardson wrote:Yes. Have to remember to check plc history
Thanks for the reply though Clint
-Clint-
