Min depth increment for drawer boxes

Scott Marshburn · Post by **Scott Marshburn** » Fri, Aug 13 2021, 4:12PM

If we set a min depth for drawer boxes when the cabinet depth is set to a depth that is too shallow for the min depth setting it gives a warning that it will be removed from the cabinet then it just removes it. Would it be possible to make it so that we can choose to keep going and lose the drawer or revert back to the original depth?

Clint Buechlein · Post by **Clint Buechlein** » Mon, Aug 16 2021, 7:23AM

Scott,

I'll pass the request along to the software engineers.

-Clint-

Scott Marshburn · Post by **Scott Marshburn** » Mon, Aug 16 2021, 9:44AM

Thanks

Thermwood / eCabinet Systems

Min depth increment for drawer boxes

Min depth increment for drawer boxes

Re: Min depth increment for drawer boxes

Re: Min depth increment for drawer boxes